Support GL-MT6000

[oliver44]

Hello all,

Can someone help me with an image for the GL-MT6000?

https://openwrt.org/toh/hwdata/gl.inet/ ... _gl-mt6000

[Lantis]

That device is only supported by Snapshot, so no we can’t do that in Gargoyle (yet).
Once it is part of a release perhaps.

[pythonic]

It appears to have been back ported into 23.05 after 23.05.2, so possibly a little closer to being supportable in Gargoyle than if it were only in main snapshots.

[oliver44]

Hello Lantis,
I see that you have compiled firmware for GL-MT6000, what is the installation procedure for gargoyle if you switch from the original firmware or from openwrt to Gargoyle?

https://lantisproject.com/gargoyle_cust ... /mediatek/

[oliver44]

I installed gargoyle on GL-MT6000, INTERNET 1Gbps, in the speed test on the wire it does not exceed 500Mbps Download and Uploud 890Mbps, Connect Via:PPPOE ipv6 dual stack, that's all Gargoyle is capable of, there are some incompatibilities?

[oliver44]

Disable Bandwidth Monitor, I reach up to 890/908 Mbps download and 880/923 upload

/etc/init.d/bwmon_gargoyle stop
/etc/init.d/bwmon_gargoyle disable

[fifonik]

What is gargoyle installation procedure for the router? Should I flash 'factory' or 'sysupgrade'?

I always thought that for upgrading from Gargoyle/OpenWRT I have to use 'sysupgrade'.

If so, why 'factory' is provided as the MT6000 is OpenWRT based?

Thanks.

[Lantis]

You can just sysupgrade for that device.
The factory image is available for those that want to get rid of the GLiNet uboot. I personally feel that it should be kept as the benefits outweigh any perceived risks.

[fifonik]

Thanks.
Flashed sysupgrade, no issues yet. Manually copy settings from old router...