"GL-inet Domino Core" target

[DESK]

Hello, I'am actually working with OpenWRT in my module, but I found too heavy and I would like to use Gargoyle.

Would be possible to implement the target GL-inet Domino Core to the lastest Gargoyle version?

Thanks in advance.
Jon

[Lantis]

Being a dev board its use cases are probably pretty limited and not mainstream.
But, i have just tested it and it compiles. So if you want to maintain your own version that is entirely doable.

Here's one you could try to begin with.
http://lantisproject.com/gargoyle_custo ... et-domino/

[DESK]

Being a dev board its use cases are probably pretty limited and not mainstream.
But, i have just tested it and it compiles. So if you want to maintain your own version that is entirely doable.

Here's one you could try to begin with.
http://lantisproject.com/gargoyle_custo ... et-domino/

Ok Lantis, thank you so much. I'm gonna try that FW.

[ispyisail]

also a bit under powered

[DESK]

Thank you for your responses,

I tested the FW you build and it seems to work fine. The only issue is that the bridge works with relayd in layer 3.

To solve that problem (to turn to layer 2), do you see possible to compile Gargoyle 1.8.1 for the "Domino" target?

Best regards,
Jon

[Lantis]

Depends on whether the device was supported in Openwrt back in barrier breaker (14.07).
If yes, it should be no problem, but not something I’m going to explore sorry. I leave it to you.
I only provided the above build because i had literally just finished a build which happened to contain it. Happy coincidence

[DESK]

Depends on whether the device was supported in Openwrt back in barrier breaker (14.07).
If yes, it should be no problem, but not something I’m going to explore sorry. I leave it to you.
I only provided the above build because i had literally just finished a build which happened to contain it. Happy coincidence

You have already helped me a lot providing me the 1.11 version, thank you.
Now it's my turn to investigate

Best regards.
Jon