Archer C59 Update bin causes full storage

[zorro31alpha]

Hello,
I have Archer C59 EU model with 16 MB of Flash Memory and 128 MB of RAM. I was able to successfully flash the base bin onto the router, now I have to install the Update. Somewhat, doing the update causes me to have Storage becomes full. May I know what's the issue and if I can somehow fix it?

[Lantis]

What version are you on, which one are you going to?

[zorro31alpha]

Hello,
1.13.0 is the version I am going for

[Lantis]

I would try 1.15

[zorro31alpha]

I am sorry, 1.15? I am not sure where is it since I didnt see it at all. could you provide me with a link please?
EDIT: I found it in the specific link

[zorro31alpha]

I am back after trying 1.15. Once again the Factory Bin does it, but update yet again causes full storage

[Lantis]

Before the 1.15 release I’ll move it to a smaller image profile but if that doesn’t fix it there’s not much that can be done.

[ektus]

I am back after trying 1.15. Once again the Factory Bin does it, but update yet again causes full storage

Why do you update twice? The factory.bin alone should do the trick, the currently available sysupdate files would install the very same version over the one in the factory.bin, I believe.

[pythonic]

Archer C59 EU model with 16 MB of Flash Memory and 128 MB of RAM.

There are two versions of this device supported: v1 and v2.
Which is yours?

[zorro31alpha]

Archer C59 EU model with 16 MB of Flash Memory and 128 MB of RAM.

There are two versions of this device supported: v1 and v2.
Which is yours?

Mine is V1