Linksys WRT32X 1.12 upgrade 1.14
Posted: Sat Dec 16, 2023 10:40 am
Hi,
Gargoyle version 1.12.0 | OpenWrt 18.06 branch
i have a lots of tweaks installed like
bearDropper, sub2rbl, syslog settings, webcam lights off and a lot of hosts with ip addresses.
Is it possible to backup most of the settings and installations and migrate it to 1.14?
Or can i make a full backup from 1.12 including installation and in case something goes wrong restore 1.12 version and restore all like it was before?
If i update to 1.14 will i lose all of it, do i have to reset to defaults again?
What is the recommended procedure for doing backup besides router configuration backup which in the past was not needed as i had to restore to defaults mostly always and set all manually again.
And what is the recommended image for a upgrade without losing all my installations, DHCP Ips and beardropper / sub2rbl (is it even possible to not lose it?)
I saved /etc/ddns_gargoyle.conf + ethers + hosts
(at the moment)
Or is there a way to remove / block these messages which come from ip v6 outside lan i guess.
"<28>dec 16 15:36:59 5minutesp miniupnpd[7406]: ssdp packet sender [fd00::e228:6dff:fe73:9fe7]:1
900 (if_index=-1) not from a lan, ignoring"
<27>dec 16 15:36:59 5minutesp miniupnpd[7406]: nlmsg_error -13 : permission denied
i can only disable "Enable UPnP & NAT-PMP service" then these messages are gone, alternative solutions are welcome.
What are the differences between 1.12 and 1.14?
Gargoyle version 1.12.0 | OpenWrt 18.06 branch
i have a lots of tweaks installed like
bearDropper, sub2rbl, syslog settings, webcam lights off and a lot of hosts with ip addresses.
Is it possible to backup most of the settings and installations and migrate it to 1.14?
Or can i make a full backup from 1.12 including installation and in case something goes wrong restore 1.12 version and restore all like it was before?
If i update to 1.14 will i lose all of it, do i have to reset to defaults again?
What is the recommended procedure for doing backup besides router configuration backup which in the past was not needed as i had to restore to defaults mostly always and set all manually again.
And what is the recommended image for a upgrade without losing all my installations, DHCP Ips and beardropper / sub2rbl (is it even possible to not lose it?)
I saved /etc/ddns_gargoyle.conf + ethers + hosts
(at the moment)
Or is there a way to remove / block these messages which come from ip v6 outside lan i guess.
"<28>dec 16 15:36:59 5minutesp miniupnpd[7406]: ssdp packet sender [fd00::e228:6dff:fe73:9fe7]:1
900 (if_index=-1) not from a lan, ignoring"
<27>dec 16 15:36:59 5minutesp miniupnpd[7406]: nlmsg_error -13 : permission denied
i can only disable "Enable UPnP & NAT-PMP service" then these messages are gone, alternative solutions are welcome.
What are the differences between 1.12 and 1.14?